Modification Method of System Parameters

Modification of system parameters can be divided into two types: http://am.co.za/ input of numerical value directly where you can then select the pre-set parameter item from a drop down menu.

Input of Numerical Value

After entering the parameter modification page, directly input the desired digit, http://am.co.za/ and then press Key OK/Confirmation on CNC Router Panel to save it or press Key ESC/Stop/Cancellation on CNC Router Panel to return to the previous menu. http://am.co.za/ Only when Key OK/Confirmation on CNC Router Panel is pressed can the modification be saved after your parameter modification each time.

For example: the modification method for the parameter "REFP Speed" is as follows.

AM.CO.ZA
Speed ( mm/min )
X Axis: 1800.000
Y Axis: 1800.000
Z Axis: 1500.000

Press the Entering Menu Page Key on CNC Router Panel button → select "5. Mfr Param" → select "5. REF. Point Set" → select "1. REFP Speed", and then press the Key OK/Confirmation on CNC Router Panel button to enter the interface shown above. http://am.co.za/ Now pressing the Key Pause/Suspend/Up on CNC Router Panel and Down Direction Key on CNC Router Panel buttons, you can select the axis speed parameter to be modified. http://am.co.za/ When the cursor is on the item currently selected, enter the new parameter value directly and then press Key OK/Confirmation on CNC Router Panel to save it.

Note: If you switch to another parameter without saving the input value during parameter modification, http://am.co.za/ this new value will not be saved and the original value will be restored.

Parameter Item Selection

Select a parameter item by directly pressing the Key Pause/Suspend/Up on CNC Router Panel or Down Direction Key on CNC Router Panel button.

For example: the modification method for the parameter "REFP Dir" is as follows.

AM.CO.ZA
Homing Direction
X Axis: Negative
Y Axis: Positive
Z Axis: Positive

Press the Entering Menu Page Key on CNC Router Panel button → select "5. Mfr Param" → select "5. REF. Point Set" → select "2. REFP Dir", and then press the Key OK/Confirmation on CNC Router Panel button to enter the interface shown above. http://am.co.za/ Now press the Key Pause/Suspend/Up on CNC Router Panel and Down Direction Key on CNC Router Panel button to select the axis direction parameter to be modified. http://am.co.za/ When the cursor is on the item currently selected, press the Key OK/Confirmation on CNC Router Panel button to enter the interface shown below, arrow indicating the currently selected item. http://am.co.za/ Then press the Key Pause/Suspend/Up on CNC Router Panel or Down Direction Key on CNC Router Panel button to select the desired item, and then press the Key OK/Confirmation on CNC Router Panel button to confirm the modification.

AM.CO.ZA
Direction of X http://am.co.za/
●   Positive
〉 Negative http://am.co.za/
 

Further Reading..

<- Back Control Panel Manuel
for EasyRoute Series CNC Routers
<- Previous Chapter
  • Panel Button Functionshttp://am.co.za/
-> Next Chapter
  • System Test & Diagnosis

EasyRoute Series CNC Routers For Sale

SKU EasyRoute 3-Axis CNC Router Price list,Router_3

© Bates Trust, Advanced Machinery ™
http://am.co.za/
. 2013/09/29 01:26 . [ Homepage | Price List | Visit Us ]